The HPC/41CV Alphanumeric Full Performance. Programmable Calculator. Owner’s Handbook and. Programming Guide. September printed on or above a key (on the Normal mode keyboard or on the Alpha keyboard) are always shown throughout this manual as they would appear in the . (up to four) or step up to an HPCV or HPCX the total number of registers can increase to (64 registers for each memory module). When allocated.

Author: Yotilar Mosho
Country: Nigeria
Language: English (Spanish)
Genre: Art
Published (Last): 16 August 2007
Pages: 279
PDF File Size: 16.45 Mb
ePub File Size: 17.57 Mb
ISBN: 501-3-94387-225-3
Downloads: 22601
Price: Free* [*Free Regsitration Required]
Uploader: JoJonos

Various information on “synthetic programming”. Both reader and manual in excellent condition.


One one side marked “”. Manaul, pages, The “flying goose” and the “backwards flying goose”. Only one such module could be installed.

This early HPC unit is equipped with golden ball-contacts for the external power supply.

Did not put back the label which covers the screws. You can enter a program that starts with a local label.

Hewlett Packard HP-41C/CV/CX/CL

One with standard key symbols, one with np-41cx labels. Reportedly, HP never built this power supply but rather release a rechargeable battery pack that had the connector built-in. Also, there isa label reading “34 03 “.


Data inside extended memory is organized in files which can store programs or data. Labels and mutli-character string labels.

This time I didn’t install a little spring which obstructed the card slot – now it works!!

Mint out of the box, everything like new except the cardboard box. German, pages, 1st issue, Cardboard box with 6 rolls of paper for the A or A printer. Refer to the table on the back of the calculator for special keys ie.

Solved: HPCX manuals – HP Support Community –

The HPA quad memory module added registers giving a total of registers. Bound printout from the pages at hp Memory space is shared between programs and data storage, allocation is performed using the SIZE command. Magnetic program card holder with 38 unmarked magnetic cards and one red card used to clean the magnetic head of the card reader.

One sheet of sticky labels for overlays, completely new. Sheet of small adhesive labels with programming functions.


Allowed for “synthetic programming” where machine code was accessible thru illegal commands. Apparently, only two such modules could be installed. After the listing has been stopped when this “END” is displayed switching to PRGM mode will display the program and it is possible to delete it step-by-step to reclaim program memory.


Math 1 ROM module, part no. Specifies the amount of number registers amnual to allocate.

Program “ST” speed test is the core speed test program. Older units will be completely reset, newer units perform a “soft reset”. Infrared module HPA, serial number The following files are available on the Systemyde website: The HPA memory module added 64 registers. About 70 magnetic cards for the magnetic card reader.

A unique feature was the barcode reader “wand” that allowed to read in programs that were printed on paper in the form of barcodes. The HPA “X-memory” module increased the extended memory space by registers bytes.

Replaced the rubber wheel – now it doesn’t work any more at all!

iPhone X