A commonly used standard to quantify finished quality of elevated and slabon- ground slabs is the ASTM Standard E The procedure outlines the method of . slab-on-ground slabs is the ASTM Standard, ASTM E The procedure outlines the method of profiling finished concrete to determine the flatness (FF) and. ASTM E Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers.
|Genre:||Health and Food|
|Published (Last):||12 December 2014|
|PDF File Size:||16.26 Mb|
|ePub File Size:||10.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
A complete metric companion to Test Method E has been developed, Test Method EM ; therefore, no metric equivalents are shown in this test method.
Module Floor Flatness and Level ASTM E with BuildIT Construction – FARO® Knowledge Base
Select all e1515 sample lines. Repeat for several runs, as shown above. A simple w orkflow from importing the files to producing a report of the surface deviation analysis.
Construct a polygon line around the area shown below. Next we will create a line for each run, the end result will appear as shown: When the traffic patterns across a floor are random, as is generally the case evaluation of the floor’s F F Flatness and F L Levelness will necessarily involve a random sampling e11155 the surface, since all of the infinite potential profiles to be seen by the traffic can not possibly be measured.
Split cloud Creating lines representing a run.
When prompted specify a location and name for the PDF report. Split cloud down to the area to be analyzed. In those instances when the traffic across a floor will be confined to specific paths, however, the requirement for random sampling is eliminated, since the floor can indeed be inspected exactly as it will be seen by all of e11155 traffic.
Such direct simulation measurements eliminate the inherent uncertainties of statistical sampling and provide profile information immediately applicable to the correction of the surface in asgm of the future traffic.
Tutorial Download If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC. Referenced Documents purchase separately The documents listed below are referenced within the subject standard asmt are not provided as part of the standard.
If you would like to download the file used in this article, download the accompanying Training Data and extract its contents aastm a folder on your PC. By now you should have a grasp of the following: Select a start point and then select an end point for the first line. Create Lines for Each Run Next we will create asstm line for each run, the end result will appear as shown: No other units of measurement are included in this standard.
In these special cases, rather than inferring the condition of the traffic paths from a random sample, it is far more useful to measure each of the traffic s1155 directly using continuous recording floor profilometer configured to run exactly in the traffic wheel paths. Lines are created to represent runs with traditional equipment.
A simple workflow from importing the files to producing a report of the surface deviation analysis. Click on the Report tab aztm click on Generate Report.
By now you should have a grasp of the following:. Historical Version s – view previous versions of standard.
Module 6.2: Floor Flatness and Level ASTM E1155 with BuildIT Construction
These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this test method. Link to Active This link will always route to the current Active version of the standard. To avoid errors, save the current project before attempting the Asmt Flatness Analysis.
Generate a Report from the Analysis The command will automatically build a standard report. Line Panel for each completed line. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Use the defaults for this exercise.